
Aqua-Pro Slimline Deluxe Undersink Reverse Osmosis
This slimline 4 stage undersink reverse osmosis is a slimline type with stainless steel PAE connection system tank, It has the Dow Filmtek 50 gallon per day membrane (200 litre)
This Reverse Osmosis Undersink 5 Stage model PSI-021-5RM is a premium low waste 1 to 1 ratio unit featuring the exclusive membrane flushing with a full size with Hi Alkalizer re-mineraliser. This re-fillable alkalizer system will produce water with a
This is a premium system made from the finest quality parts available without compromise.
This Reverse Osmosis Undersink 5 Stage model PSI-021-5RM-HA is a premium low waste 1 to 1 ratio unit featuring the exclusive membrane flushing with a full size Hi Alkalizer re-mineraliser. This re-fillable alkalizer system will produce water with an alkalinity of 8.5 to 9.5 pH.
It has the Dow Filmtec 300 litre per day TFC membrane, the 300 litres is rated at 50 psi (350 kpa) but will produce up to 450 litres per day higher pressures, what this means is the system will fill faster than most systems on the market. This system has an auto shut-off device that closes off the in-feed supply when the storage tank has filled.
All components are NSF certified to standards 042, 053 & 058
Replacement trio of cartridges (ROCDU-02) which is the annual change are $55.00, how often the alkalizer will need to be re-filled will depend on usage, this will normally ocour about every second year with the cost of the re-fill $20.00 if ordered with other cartridges.
See faucet (tap) range, click here to view.
Click here to down load a sample of the installation instructions pdf format
Supplied with QMP-300-HP U.S.A. made housing 10" Australian Standards AS3497 with 1/4" NPT threaded ports. This housing is tough with a burst strength of 575psi (4000kpa) and is tested to AS3497 which means it has been tested from 0 to 700kpa and back to 0 kpa 100,000 times without failure, cracking or distortion.
With these premium systems we supply the 550 kpa pressure limiting valve with dual check valves which is a plumbing code requirement, the valve is also Watermark AS1357-2 licence no 02596 as the watermark is also a plumbing code requirement.
We supply the 550Kpa PLV with the premium system so the filter system runs faster than other units on the market.
Highest Quality QMP-300 US housings, standard size 10 inch (9 ¾" (248mm) NSF certified (worlds leading certification authority) NSF/ANSI standard 042 certification, also tested and certified to Australian Standards 3497
Removes 98% of Fluoride.
For membrane treatment rates click here.
Dimension
* Main filter unit - 42cm wide, 42cm high and 14cm Deep.
* Storage tanks - Click here for tank details. Tanks can either stand up or lay down
4.2L - 33cm high and 20.5cm diameter
9L - 39cm high and 24cm diameter
12L- 39cm high and 27.5cm diameter
1 Micron food grade polyspun sediment filter 9 ¾" (248mm) (standard size) U.S. made
Matrikx CTO/2 quality carbon cartridge 9 ¾" (248mm) 22,500 litres chlorine rating, U.S. made
Genuine Omnipure CL10RO- Coconut carbon post filter, highest quality possible. U.S. made
Genuine Dow Filmtec TFC Membrane (standard by which all other membranes are measured)
The re-mineraliser (Alkalizer) which contains crushed Marble or crushed Limestone and coral sand. The material contained in the cartridge is mostly calcium but also contains trace elements of other minerals, this is the same material suppied with what are called Pi systems or Alkalizers, we are prevented from supplying a specification sheet as the amount of re-mineralisation is dependant on the pH of the water, if we had the unit tested at say a pH of 6.0 the cartridge would result in an X factor of re-added minerals which would be misleading if the water in your unit on your water supply had a pH of say 6.4 before the re-mineraliser which would result in a lower added amount.
The re-mineraliser cartridge in this unit can be un-done and some of your own media can be added if you wish.
The re-mineraliser cartridge contains 2/3 crushed calcite (marble) and 1/3rd coral sand, the coral sand is the component that puts the pH up, you can add extra if you wish to go higher in pH. The coral sand will dissolve away over time and to maintain the high pH this will need extra added at times, you can purchase additional coral sand if you wish at $20.00 per kilo. The calcite is normally replaced after the 4th year.
The reverse osmosis process can't pick the pepper out of the salt so to speak, so it is better to be sure and remove all the poisons from the water than be worried about the minerals that have been removed. Health experts say that you obtain the minerals that your body needs from your diet, you should not rely on water as a mineral source as there is very little available to the body in water as the minerals are totally dissolved, the re-mineraliser in this system is about balancing the pH as a taste issue.
Main filter unit size, 42 cm high, 42 cm wide & 14 cm deep. 9 litre stainless steel storage tank (exceeds drinking water guidelines) NSF Certified. If space is an issue we also offer a 4.2 litre or 12 litre tank.
Premium systems now have the lowest waste ratio of all systems on the Australian market, using a Patented combination membrane flushing valve/flow restrictor means the waste ratio is about 50% less waste than other brands, waste ratio is now about 1 to 1.
Click here to obtain more information about waste ratios
Installation choice 1/2" tee olive fitting, 3/4"dishwasher adapter or 1/2" easy fit braided line flick mixer adapter, our systems take the average handyman 1/2 to 1 hour to install
Mains connect systems click here to view how each are installed water filter parts
550 kpa pressure limiting valve, genuine QMP Stainless Steel dedicated faucet. Housing spanner to ease cartridge changes.
Click here for selection Advice
PSI Systems are Better Than Other Brands, click here to find out why
If you option to have the hand held TDS meter with the unit beware that the system will have an elevated reading due to having the reminerliser cartridge.
All reverse osmosis systems require a minimum pressure of 40 psi (280kpa) with 50 psi (350kpa) or more is ideal. If you are unsure what your pressure is check with your local Council or water authority.
Operating pressure requirements 280 to 550 kpa (40-80 psi)
product comes complete, ready for installation.
Substance treatment rates below for TFC reverse osmosis, click here for a full list in PDF.
This slimline 4 stage undersink reverse osmosis is a slimline type with stainless steel PAE connection system tank, It has the Dow Filmtek 50 gallon per day membrane (200 litre)
The BOSS 031-DI-RM-RF is one of the very few reverse osmosis system on the market that can offer the removal of 99.99% of flouride and many more contaminates. The BOSS 031-DI-RM has state of the art technology with on board monitoring equipment. The mon
This Reverse Osmosis Undersink 4 Stage model PSI-021-4P-GM is a premium low waste 1 to 1 ratio unit featuring the exclusive membrane flushing. It has the Dow Filmtec 300 litre per day TFC membrane, the 300 litres is rated at 50 psi. Optional ALKALIZE
200 litre per day genuine Dow Filmtec membrane @50 psi, 300 litres @ 87 psi. LOW WASTE 1.25 to 1. All components are Australian Standards and or NSF certified. Optional ALKALIZER
The QRO4 are often also sold under the names HydrROtwist or PuRO Twist. The QRO4 that we stock have the faster 50 gallon per day (200 litre) membrane compared to others which have slower membranes. These are so easy to change the cartridges on that
This Reverse Osmosis Undersink 5 Stage model PSI-021-5RM is a premium low waste 1 to 1 ratio unit featuring the exclusive membrane flushing with a full size with Hi Alkalizer re-mineraliser. This re-fillable alkalizer system will produce water with a